Apache Technologies Bullseye 3 Manual do Operador descarregar pdf (Página 13)

Operation

Laser Beam Averaging. The laser beam averaging

function senses the laser strikes and applies the

highest level of averaging appropriate for the laser

rotation speed. This may stabilize the LED display

if the laser set-up is unstable due to windy conditions or long range

applications.

The factory default setting is Laser Beam Averaging on.

The receiver can be set for no averaging. In this mode the receiver

processes and displays every single laser strike. To change between

the two modes, turn the receiver on. Press and hold the power switch

and then press and release the deadband switch. The outer on-grade

LED's will ﬂash conﬁrming the averaging function is activated. Pressing

the power / deadband switch combination again while the averaging

function is activated will toggle between on and off.

When the center LED is on, averaging is on. When the center LED is

off, averaging is off.

Averaging ON Averaging OFF

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Apache Technologies Bullseye 3 Manual do Operador Página 13